Front Safety Belt Retractor

Operation number: 88404-2

Front safety belt retractor

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Disconnect the negative battery lead.

Information about the handling and storage of pyrotechnic SRS components. Refer to: Handling non-deployed pyrotechnical part Handling Non-Deployed Pyrotechnical Part

Remove the side panel at the front edge. Refer to: Side panel rear seat Side Panel Rear Seat





Torque: Seat belt pre-tensioner to body, 4 Nm





Detach the connector. Refer to: Igniter wire connector Igniter Wire Connector
Torque: Safety belt retractor front to body, 40 Nm

Installation

Install in reverse order.

Check the seat belt function. Refer to: Seat belt function, check Testing and Inspection.

Carry out an inspection. Refer to: Supplementary restraint system (SRS), inspection Testing and Inspection