Seal CV Joint Housing, Replacing

Seal CV joint housing, replacing

Removal

Preparations
Remove the drive shaft on the right-hand side, see Drive shaft right, replacing Drive Shaft Right, Replacing , and the left-hand side, see: Drive shaft left, replacing Drive Shaft Left, Replacing.

Removing the sealing ring for the CV joint housing from the stub axle




Carefully remove the sealing ring.

Note! The sealing ring will be used again during installation.

Installation

Installing the sealing ring for the CV joint housing on the stub axle





Note! Replace the sealing ring if it is damaged or worn.

Clean around the constant velocity joint before installing the sealing ring.
Carefully install the sealing ring. Ensure that the sealing ring is correctly positioned on the drive shaft.

Finishing
Install the drive shaft on the right-hand side, see Drive shaft right, replacing Drive Shaft Right, Replacing , and the left-hand side, see: Drive shaft left, replacing Drive Shaft Left, Replacing.