Global Positioning System Display Unit: Service and Repair

Receiver GPS, TMC (ATM), replace

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Location

Location Of Components:

1. The AM/FM receiver, see also Receiver AM/FM (ATM), replacing Service and Repair
2. Receiver TMC
3. Receiver GPS.

Preparatory work




Ignition off.
Remove the cantrail. See Panel cantrail, replacing Panel Cantrail, Replacing.

Removing the receiver GPS/TMC





Note! The TMC receiver must always be removed before the GPS receiver. See the illustration.

- Disconnect connector
- Remove the screws
- Remove the receiver.

Installing the GPS/TMC receiver





Note! The GPS receiver must always be installed before the TMC receiver. See the illustration.

Align the receiver.
Install the screws. Tighten.
Connect any connectors

Finishing work
Install the cantrail. See Panel cantrail, replacing Panel Cantrail, Replacing.
Test the function.