Rear Seat Backrest Covers and Cushion

Rear Seat Backrest Covers and Cushion

• The description relates to the 2/3 unit of the rear seat backrest. The work steps for the 1/3 unit are to be derived from this.

Removal

- Switch off the ignition.

- Remove the 2/3 unit of the bench seat. Refer to => [ Bench Seats ] Bench Seats.

- Remove the 2/3 unit of the rear bench seat. Refer to => [ Rear Seats ] Rear Seats.

- Remove the outer trim of the 2/3 unit. Refer to => [ Outer Trims of the Rear Seats ] Outer Trims of the Rear Seats.

- Remove the pass-through. Refer to => [ Pass-Through ] Pass-Through.

- Remove the headrest of the 2/3 unit. Refer to => [ Headrest ] Headrest.

- Remove the headrest guides of the 2/3 unit. Refer to => [ Rear Headrest Guides ] Rear Headrest Guides.

- Remove the rear center belt anchor. Refer to => [ Rear Center Belt Anchor ] Rear Center Belt Anchor.

- Use the wedge (T10383) to carefully pry the belt extraction panel - 1 - from the console - 2 -.






- Use a small screwdriver to lift the retaining tab - 1 - in the trim - 2 - slightly and detach the trim from the backrest.






- Remove the second trim in the backrest as described.

- Pry out and remove the profiles - 3 - on the back of the backrest - 2 - - arrow -.






- Roll up the cover - 1 - on the sides.

- Remove the cushion - 2 - and cover - 3 - from the backrest - 1 -.






- Cut all upholstery clips in the cushion channels and detach the cover from the cushion.

Installation

Installation is performed in the reverse order of removal.

• When installing upholstery clips, use upholstery clip pliers (V.A.G 1634).