Clutch Release Mechanism Overview

Clutch Release Mechanism Overview






1 Transmission

2 Input Shaft Seal

• Removing and installing, refer to => [ Input Shaft Seal ] Input Shaft Seal.

3 Clutch Slave Cylinder with Release Bearing

• Must be replaced together, because they are a single unit.

• Do not wash the bearing, just wipe it off.

• Replace any loud bearings together with the clutch slave cylinder.

• Some clutch slave cylinders have a divided feed line. Refer to => [ Clutch Slave Cylinder with a Divided Supply Line: ] Clutch Release Mechanism.

• Removing and installing, refer to => [ Clutch Slave Cylinder with Release Bearing ] Service and Repair.

• For release bearing with an additional plastic washer, refer to => [ Release Bearing with an Additional Plastic Washer: ] Clutch Release Mechanism, pressure plate allocation, refer to => [ Only for release bearings with an additional plastic washer: Pressure plate diaphragm spring () with a slightly lower installed height. ] Clutch Release Mechanism.

• Allocation. Refer to the Parts Catalog.

4 Bolt

• Always replace

• Quantity: 3

• Without locking fluid - 12 Nm (clutch slave cylinder with a metal housing).

• With locking fluid - 15 Nm (clutch slave cylinder with a plastic housing).

• Pay attention to the thread pitch on the bolt when cleaning the threaded hole in the clutch housing.

• Carefully tighten diagonally in small stages so that clutch slave cylinder bolt tabs do not break off.

5 O-ring

• Install on the line connection.

• Install using brake fluid.

• Allocation, refer to the Parts Catalog.