Engine Mount: Adjustments

Engine and Transmission Mount, Adjusting

Procedure

When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:

• Route all wires and lines so that the original path is followed.

• Ensure sufficient clearance to all moving or hot components.

- Hold the engine in its installed position. Refer to => [ Engine, Holding in Its Installed Position ] Engine, Holding in Its Installed Position.

• The subframe bolts may only be loosened when the engine is supported using the engine support bridge (10-222 A).

- Replace the engine mount to engine mount bracket bolts - arrows - one after the other (if not already done) and tighten them by hand.






- Replace the transmission mount to transmission mount bracket bolts - arrows - one after the other (if not already done) and tighten them by hand.






- Loosen the bolts for the engine and transmission mounts approximately 2 turns.

Engine Mount





• There must be a distance of at least 10 mm - a - between the engine mount bracket and right longitudinal member.

• The casting edge on the engine mount bracket - 2 - must be parallel to the engine mount support arm - 1 -.

Transmission Mount





- The edges of the transmission mount support arm - 1 - and the transmission mount - 2 - are parallel.

• Dimension - x - is the same size on both sides of the mount.

- Tighten the engine and transmission mount bolts.

• For the correct tightening specifications, refer to => [ Fastener Tightening Specifications ] Engine Assembly - Fastener Tightening Specifications.

Install in reverse order of removal. When doing this note the following:

• Make sure the fuel lines are securely fastened.

• Do not interchange the supply and return lines (the return line is blue or with a blue mark, the supply line is black).

- Observe the safety precautions after connecting the battery.