Access/Start System Antenna 1 In Vehicle Interior (R138)

Access/Start System Antenna 1 In Vehicle Interior (R138)

The access/start authorization antenna 1 in vehicle interior is located under the front center console, in front of the selector lever.

• No coding, basic setting or adaptation is necessary if access/start system antenna 1 in vehicle interior is replaced. Erase the resulting entry in the DTC memory using the Vehicle diagnostic tester.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the button strip inside the center console. Refer to => [ Buttons In Center Console Storage Compartment ] Buttons In Center Console Storage Compartment.

- Remove the access/start system antenna 1 in vehicle interior - 1 - - arrow -. Pay attention to the wires still connected.






- Disconnect the connector - 2 - and remove the access/start system antenna 1 in vehicle interior - 1 - from the vehicle.

Installing

Install in reverse order of removal.

• It is not possible to remove the bracket for the access/start system antenna 1 in vehicle interior in the center console without breaking it. If the antenna bracket must be removed, then install a new bracket so that there will not be any rattling noises and the KESSY system will continue to work correctly.