Reservoir

Reservoir


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the filler tube. Refer to => [ Filler Tube ] Filler Tube.

- Remove the front bumper cover.

To avoid interchanging the washer fluid line connections on the Windshield and Rear Window Washer Pump (V59) , the connections on the pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

- Turn the clip on the hose connection - 3 - and - 5 - to open it and then remove the windshield and rear window washer pump- 4 -.






- Catch any draining washer fluid in a suitable container.

- Disconnect the connector - 6 - from the windshield washer fluid level sensor (G33) - 7 -.

- Pull the windshield and rear window washer pump (V59) - 4 - out of the container and disconnect the connector - 2 -.

- Pull the headlamp washer pump (V11) - 9 - out of the container and disconnect the connector - 10 -.

- Remove the bolts - arrows - from the reservoir and then remove the reservoir from the vehicle.






Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specifications. Refer to => [ Windshield Washer System Overview ] Windshield Washer System Overview.

- Bleed the headlamp washer system. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.