Removal and Replacement

Data Bus On Board Diagnostic Interface (J533)

The data bus on board diagnostic interface is located in the right side of the driver footwell next to the steering column.

The "replace the Data bus OBED interface" procedure must always be performed before the data bus on board diagnostic interface is removed, refer to => [ Replacing ] Replacing.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the trim on the driver side.

- Disconnect the connector - 1 -.






- Press the tabs - 3 - together - arrows - and pull them out of the holes.

Installation

Install in reverse order of removal.