Replacing

Replacing

The procedure "replace the Data bus OBED interface" contains the following work to be completed:

• If a new Data bus OBED interface (J533) is installed, it must be coded online.

The procedure to "replace the Data bus OBED interface" can only be performed with the Vehicle diagnostic tester in the "guided fault finding" function.

- Connect the Vehicle diagnostic tester.

- Select Guided Fault Finding.

- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

• Body

• Electrical Equipment

• 01 - On Board Diagnostic (OBD) capable systems

• 19 - Data bus on board diagnostic interface J533

• Functions of the Data Bus On Board Diagnostic Interface

• Replace control module