Upper A-pillar Trim

Upper A-Pillar Trim

• The following describes removing and installing on the left side of the vehicle. Removing and installing on the right side is identical.

Removing

- Remove side instrument panel covers. Refer to => [ Instrument Panel Side Covers ] Instrument Panel Side Covers.

- Remove the A-pill center trim. Refer to => [ Center A-Pillar Trim ] Center A-pillar Trim.

- Remove airbag emblem - 1 - and remove screw - 2 - (4 Nm).

- Remove trim in area of mounting clip - 3 - from mounts - arrow A -.

- Remove trim from door seal piping.

- Pull trim out of front mount - arrow B -.

- Remove trim in rear area from instrument panel - arrow C -.

• When installing, airbag emblem - 1 - must be replaced.

• Before installing, inspect the securing clips for damage and replace if necessary.






Installing

- Install in reverse order of removal.