Center Console, CC from MY 2010

Center Console, CC from MY 2010

• To provide a better overview, the seats are not shown in the following illustration. It is not necessary to remove the seats.

Removing

- Remove the footwell trim. Refer to => [ Footwell Trim ] Footwell Trim.

- Remove the front ashtray or the front storage compartment. CC from MY 2010. Refer to => [ Front Ashtray or Front Storage Compartment, CC from MY 2010 ] Front Ashtray or Front Storage Compartment, CC from MY 2010.

- Remove the Infotainment trim. CC from MY 2010. Refer to => [ Infotainment Trim, CC from MY 2010 ] Infotainment Trim, CC from MY 2010.

- Remove the cover, "Climatronic/Climatic", CC from MY 2010. Refer to => [ Climatronic and Climatic Cover, CC from MY 2010 ] Climatronic and Climatic Cover, CC from MY 2010.

"Climatic" A/C System with Manual Control

Remove the heater and A/C controls, Climatic.

"Climatronic" A/C System with Automatic Control

- Remove the front A/C display control head (E87) with the Climatronic control module (J255).

- Remove rear trim. Refer to => [ Rear Trim ] Rear Trim

- Remove the two bolts - 1 -.

- Remove the two nuts - 2 -.

• In order to remove screws - 4 -, - 6 -,- 7 - and - 8 -, seats must be moved accordingly.

- The caps - 3 - and - 5 - are omitted.

- The bolts - 4 - and - 6 - are omitted.

- Remove the screws - 7 - and - 8 -.

- Raise center console in rear area.

Vehicles with an AUX-In socket in the center console

- Remove the AUX IN socket.

- Loosen the center console from the centering tabs - 9 - in the center console.






Installing

- Insert center console in the two centering tabs - 9 - in instrument panel.

• Check whether heating and cooling channels - 10 - are precisely fit to the heating and cooling channels in the center console.

Vehicles with an AUX-In socket in the center console

- Install the AUX IN socket.

- Secure center console with two screws - 1 - (1.5 Nm).

- Bolt in center console in rear area with two nuts - 2 - (6 Nm).

- The caps - 3 - and - 5 - are omitted.

- The bolts - 4 - and - 6 - are omitted.

- Secure center console in center and side area with two bolts - 7 - and - 8 - (1.5 Nm).






Rest of installation of center console is the reverse order of removal.