FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Headliner, Lowering and Installing, Passat CC from MY 2009 and CC from MY 2010







Headliner, Lowering and Installing, Passat CC from MY 2009 and CC from MY 2010

When working on the side curtain airbag, the roof insulation/reinforcement or roof antenna, remove the headliner. It is not necessary to do this when removing the windshield.

Removing

- If equipped, open the Panorama sunroof.

- Switch off the ignition.

- Remove the front interior and reading lights.

- Remove the roof grab handles on vehicles without Panorama sunroof => [ Roof Grab Handles ] Service and Repair

- Remove upper trim on A-pillars => [ A-Pillar Upper Trim for Passat CC from 2009 and CC from 2010 ] A-Pillar Upper Trim for Passat CC from 2009 and CC from 2010

- Remove the upper B-pillar trim from the brackets => [ Upper B-Pillar trim, Tightening and Loosening from Mount for Passat CC from 2009 and CC from 2010 ] Upper B-Pillar trim, Tightening and Loosening from Mount for Passat CC from 2009 and CC from 2010.

- Remove visors => [ Basic Sun Visors, Passat from MY 2006 and Passat Wagon from MY 2006 ] Basic Sun Visors, Passat from MY 2006 and Passat Wagon from MY 2006.

- Remove the C-pillar trim:

Vehicles not equipped with a sun shade => [ C-Pillar Trim, Vehicles without Sun Shade, Passat CC from MY 2009 and CC from MY 2010 ] C-Pillar Trim, Vehicles without Sun Shade, Passat CC from MY 2009 and CC from MY 2010

Vehicles equipped with a sun shade => [ C-Pillar Trim, Vehicles with Sun Shade, Passat CC from MY 2009 and CC from MY 2010 ] C-Pillar Trim, Vehicles with Sun Shade, Passat CC from MY 2009 and CC from MY 2010

- Using the trim removal wedge (3409) remove the caps from the mirror - arrows -.






- Disconnect the connector - 1 - and remove the screws - 2 - (1.6 Nm).






- On vehicles equipped with a Panorama sunroof, remove the clamping profile - 1 - from the mounting clamps - 2 - - arrow -using the release tool (T10236) and the trim removal wedge (3409).

In total, the clamping profile is attached by 20 clips.






- Loosen the headliner around the C-pillars toward the inside and out of the catches - arrow -.






- Pull the headliner - 1 - downward and out of the remaining retainers.






Installing

- Install in reverse order of removal.

The installation of the headliner is made much easier by replacing clips "part number: 1K0 867 633" below the roof grab handle. Therefore, replacing the old clips is recommended.