Flywheel: Service and Repair

Flywheel

Special tools, testers and auxiliary items required

• Flywheel Retainer (3067)

Removing

- Remove the transmission.

To prevent damage to the dual mass flywheel when removing, the bolts - B - must not be loosened using an air powered or impact wrench. Always remove the bolts by hand only!

- Mark the position of the dual mass flywheel to the engine.

- Rotate the dual mass flywheel - A - so that the bolts - B - are centered to the holes - arrows -.






- When removing the bolts - B -, make sure that the bolt head does not contact the dual mass flywheel - arrows - and thereby cause damage when turning it further.

- Insert flywheel retainer (3067) into the hole in the cylinder block - B -.






- Remove the dual mass flywheel by hand.

Installing

Install in reverse order of removal. Note the following:

Cylinder block overview, transmission side. Refer to => [ Cylinder Block Overview, Transmission Side ] Cylinder Block Overview, Transmission Side.

- Secure with new bolts.

- Install the flywheel retainer (3067) into the hole in the cylinder block - A -.