Instrument Cluster

Instrument Cluster

Before removing the instrument cluster, perform the => [ Instrument Cluster, Replace ] Instrument Cluster, Replace procedure to read out the data saved in the Instrument Cluster Control Module (J285).

• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

• It is not necessary to remove the steering wheel.

- Pull the steering wheel all the way out and then lower as far down as it will go.

- Remove the instrument cluster frame..

- Remove the upper section of the steering column and instrument panel trim panel.

- Remove the screws - 2 - and - 3 -.






- Pull the instrument cluster - 1 - back out of the instrument panel while being careful of the connected wires.

- Move the securing clip - 1 - in - direction of arrow - and disconnect the connector - 2 -.






- Remove the instrument cluster from the vehicle.

Installing

Install in reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification shown in => [ Instrument Cluster Overview ] Instrument Cluster Overview.