Left Temperature Door Motor (V158) and Potentiometer/Actuator (G220)

Left Temperature Door Motor (V158) and Potentiometer/Actuator (G220)

Removing

- Remove the driver footwell vent. Refer to => [ Footwell Vent, Driver Side ] Footwell Vent, Driver Side.

- Remove the left footwell (in the middle console). Refer to Storage Compartments, Covers and Trim.

- Remove the side bolts on the lower mount - 1 - (9 Nm) for the heater and A/C unit.

- Pull the mount in the direction of the brake pedal - arrow - and secure it with the cable ties.






- Disconnect the connector - 5 - from the left temperature door motor - 3 -.

- Remove the bolts - 6 - (1.5 Nm).

- Loosen the connecting rod - 2 - on the temperature door.

- Remove the left temperature door motor - 3 - and the connecting rod - 2 -, from the counterholder - 4 - and from the heater and A/C unit.

- Disconnect the adjusting lever - 1 - for the left temperature door motor - 3 - from the connecting rod - 2 -.






Installing

Install in reverse order of removal.

- Install the wiring harness so that it cannot come in contact with any moving parts (for example, the lever on the motor).

• After installing the left temperature door motor, check the recirculating air door function.

• Perform a "basic setting" using the Vehicle Diagnostic Tester. Refer to => [ Checking and Adjusting Components, Automatic Control System ] Checking and Adjusting Components, Automatic Control System.

• Check and erase the DTC memory.