Selector Lever Boot, Separating from Handle

Selector Lever Knob and Boot






1 Clamp

• For fastening the knob to the selector lever.

• Will be damaged during removal, always replace.

2 Knob with Boot

• Removing, refer to => [ Selector Lever Knob and Boot ] Selector Lever Boot, Separating from Handle.

3 Shift Cover

• Removed together with the knob and boot.

Special tools, testers and auxiliary items required

• Hose Clamp Pliers (V.A.G 1275)

Removing

- Move the selector lever into the "D" position.

- Unclip the shift cover from the trim.






- Disconnect the connector from the shift cover and pull the boot over the knob.






- Remove the clamp.

- Remove the knob from the selector lever. Do not push the button.

• The knob is removed together with the shift cover.

The button locks in the installed position when the knob is removed. Never push the button after removal or the knob can no longer be installed.

Installing

Installation is performed in the reverse order while observing the following:

• The selector lever is in the "D" position.

• The button in the knob is in the installed position - arrow - and points in the direction of travel during installation.






• There is the possibility that the button can be pressed into the knob. Never install the knob when the button is pressed in.

• A new handle is delivered with an assembly fastener. Pull out the fastener just prior to installation.






If the button was pushed in by mistake, the installed position can be set again. To do this, press the button and push the assembly fastener all the way in, release the button and then pull the assembly fastener back out again. The button engages in the installed position.

- Install the knob on the selector lever with a new clamp until it snaps into place.

- Push the button in the selector lever knob in.

• In the case of incorrect assembly, the button remains in the knob after operation. The knob must be reinstalled.

- Secure the clamp - arrow - using the hose clamp pliers (V.A.G 1275).






Further installation is performed in the reverse sequence.