Shift Solenoid: Service and Repair

Solenoid Valve and Sensor Wiring Harness

Removing

- Drain the transmission fluid. Refer to => [ Transmission Fluid, Draining and Filling ] Transmission Fluid, Draining and Filling.

- Remove the valve body. Refer to => [ Valve Body ] Valve Body.

- Disconnect the connectors from the transmission.

- 1 - transmission sensor terminal

- 2 - connector for solenoid valves






- Disconnect the connector housing from the transmission.

- Disconnect the connector housing together with the wiring harness outward from the transmission housing.

Installing

- Replace the seal on the connector housing.

- Carefully guide the wiring harness from the outside into the transmission.

- Lubricate the connector housing seal with transmission fluid and then press the connector housing all the way into the transmission.

- Connect the connector housing, tightening specification, refer to => [ Fastener Tightening Specifications ] Specifications.

- Install the valve body. Refer to => [ Valve Body ] Valve Body.

- Fill with transmission fluid and check the level. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.