Sealing Flange and Flywheel Overview

Sealing Flange and Flywheel Overview

Servicing the Clutch:





1 Seal

• Do not lubricate or grease the sealing lip on the seal.

• Before installing, remove any remaining oil from the crankshaft journal with a clean cloth.

• Crankshaft seal, ribbed belt side, replacing. Refer to => [ Crankshaft Seal, Belt Pulley Side ] Service and Repair.

2 Sealing Flange

• Must be located on the alignment sleeves.

• Removing and installing, refer to => [ Sealing Flange, Belt Pulley Side ] Service and Repair.

• Install using silicone sealant (D 176 404 A2). Refer to => [ Sealing Flange, Belt Pulley Side ] Service and Repair.

3 Cylinder Block

• Crankshaft overview. Refer to => [ Crankshaft Overview ] Crankshaft Overview.

• Piston and connecting rod overview. Refer to => [ Piston and Connecting Rod Overview ] Service and Repair.

4 Bolt

• 60 Nm + an additional 90° (1/4) turn.

• Always replace.

5 Flywheel

• To loosen the bolts, secure using flywheel retainer (3067).

6 Intermediate Plate

• Must be located on the alignment sleeves.

• Be careful not to damage or bend when installing.

7 Bolt

• 15 Nm

8 Sealing Flange with Seal

• Removing and installing, refer to => [ Sealing Flange, Transmission Side ] Sealing Flange, Transmission Side.

• With the sensor wheel for the engine speed sensor.

• Always replace as a complete unit.

• Do not lubricate or grease the sealing lip on the seal.

• Wipe off any oil on the crankshaft bearing journal with a clean cloth before installing.

• Use the support sleeve provided to install.

9 Engine Speed Sensor (G28)

• Bolt, 5 Nm

• Removing and installing, refer to => [ Engine Speed Sensor G28 ] Service and Repair.