Fluid Pressure Sensor/Switch: Service and Repair

Hydraulic Pressure Sensor 1 and 2

• On transmissions that were built after 11.05, the hydraulic pressure sensor has been discontinued.

• Allocation, refer to the parts catalog.

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

Removing

The sensors must always be replaced together.

- If still installed, remove the oil filter. Refer to => [ Oil Filter ] Service and Repair.

- Carefully disconnect the connectors for automatic transmission hydraulic pressure sensor 1 (G193) - 1 - and theautomatic transmission hydraulic pressure sensor 2 (G194) - 2 -.





- Remove both sensors.

Installing

The sensors must always be replaced together.

- Install the 2 new sensors and tighten them to 5 Nm.





- Connect the connectors onto the sensors - 1 and 2 - until seated.

The connectors must engage.

- Install the oil filter. Refer to => [ Oil Filter ] Service and Repair.

- After installation, fill with Automatic Transmission Fluid (ATF), check the ATF level, and top off if necessary. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] Automatic Transmission Fluid Level, Checking and Filling.