Separable Stabilizer Bar Assembly Overview

Separable Stabilizer Bar Assembly Overview






1 Separable Stabilizer Bar

• Removing and installing, refer to => [ Separable Stabilizer Bar ] Front Suspension.

• Bleeding, refer to => [ Separable Stabilizer Bar, Bleeding ] Separable Stabilizer Bar, Bleeding.

2 Lower Stabilizer Bar Mount

• Installation position:

• Mark on stabilizer bar before removing.

• Large outer diameter must point outward.

• Different versions, allocation, refer to the Electronic Parts Catalog (ETKA).

3 Hydraulic Line

• Tighten to 40 Nm at the stabilizer bar.

• Insert in bracket at front in direction of travel => [ (Item 5) Bracket ].

• With color marking.

• When pressure is built up in this line, coupling disc in stabilizer bar closes.

• Counterhold at hex of union nut using open-end wrench when loosening connection.

4 Front Axle Stabilizer Decoupling Sensor (G484)

• Can be tested in "guided fault finding" using the Vehicle diagnosis, testing and information system (VAS 5051).

5 Bracket

6 Hydraulic Line

• Tighten to 20 Nm at the stabilizer bar.

• Insert in bracket at rear in direction of travel => [ (Item 5) Bracket ].

• When pressure is built up in this line, coupling disc in stabilizer bar opens.

• Counterhold at hex of union nut using open-end wrench when loosening connection.

7 Bolt

• 3 Nm

8 Seal

• Always replace after removal.

9 Bracket

• Secure to stabilizer bar using clamp => [ (Item 12) Clamp ].

10 Bleeder Nipple

• 5 Nm

11 Dust Cap

12 Clamp

• Installation position.

13 Clamp

• 8 Nm

• Only on vehicles with active body control.

• Installation position.

14 Upper Stabilizer Bar Mount

• Installation position:

• Mark on stabilizer bar before removing.

• Large outer diameter must point outward.

• Different versions, allocation, refer to the Electronic Parts Catalog (ETKA).

Installation Position of Clamp for Mounting of Hydraulic Lines at Separable Stabilizer Bar





• Clamp fastener - 1 - must be above bracket - 2 -. From this it follows that the clamp is tightened from below.

• Clamp must directly make contact at bracket - 2 - - arrow -.

Stabilizer Bar Mount Clamp Installation Position on Vehicles with Active Body Control





• The bolt - 1 - must be at the top.