Windshield and Headlamp Washer Fluid Reservoir

Windshield and Headlamp Washer Fluid Reservoir

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove filler tube for tank for windshield washer system and headlamp washer system. Refer to --> [ Windshield and Headlamp Washer Fluid Reservoir Filler Tube ] Windshield and Headlamp Washer Fluid Reservoir Filler Tube.

- Remove front bumper cover.

• To avoid interchanging the washer fluid line connections on the Windshield and Rear Window Washer Pump (V59), the connections on the pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

- To release, twist the securing clips at the hose connections - 3 - and - 5 - and disconnect them from the Windshield and Rear Window Washer Pump (V59) - 4 -.





- Save the drained washer fluid in a suitable container.

- Disconnect harness connector - 6 - from Windshield Washer Fluid Level Sensor (G33) - 7 -.

- Remove Windshield and Rear Window Washer Pump (V59) - 4 - upward out of tank and disconnect harness connector - 2 -.

- Pull Headlamp Washer Pump (V11) - 9 - upward out of tank and disconnect harness connector - 10 -.

- Remove mounting bolts - arrows - and remove tank from vehicle.





Installing

Install in reverse order of removal, noting the following:

- Tighten all fasteners according to value in table. Refer to --> [ Windshield Washer System Tightening Specifications ] [1][2]Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to --> [ Headlamp Washer System, Bleeding ] Procedures.