Cowl Moulding / Trim: Service and Repair

Plenum Chamber Cover Assembly Overview





1 Plenum chamber cover

• Must only be pulled out of binding profile by hand.

• Removing and installing => [ Plenum Chamber Cover Assembly Overview ] Service and Repair

2 Plenum chamber - bulkhead

3 Windshield

4 Seal - plenum chamber

5 Binding profile

• Is part of windshield.

Plenum Chamber Cover, Removing





- Remove wiper arms

CAUTION!
Do not pry the plenum chamber cover off with any tools. Window will be damaged and may crack later

- Pull off seal of plenum chamber - 4 - on the entire length of facing wall - 2 - of plenum chamber.

- Pull out plenum chamber cover - 1 - starting at right carefully upward from binding profile - 5 -.

Plenum Chamber Cover, Installing





CAUTION!
Striking the plenum chamber cover can cause cracks in the windshield.

- Spray binding profile - 5 - with soap solution so that plenum chamber cover - 1 - can be pressed in more easily.

- Place plenum chamber cover - 1 - onto binding profile - 5 - and engage it with binding profile - 5 - starting from center using light pressure.

- Install plenum chamber seal - 4 - and windshield wiper.

• In new windshields, an insert is installed in the binding profile. This insert must be removed before installing the plenum chamber cover.