Installation

SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION

1. INSTALL REAR SEAT OUTER BELT ASSEMBLY

(a) Check the degree of the tilt when the ELR begins to lock.

(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

NOTICE:
Do not disassemble the retractor.

(b) Align the claw with the seat belt positioning hole and install the rear seat outer belt assembly with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY Installation

3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for Reclining Seat Type) Installation

4. INSTALL REAR SEAT SHOULDER BELT HOLE COVER

(a) Engage the 4 claws and install the rear seat shoulder belt hole cover.

5. INSTALL REAR SEAT SHOULDER BELT COVER

(a) Engage the 4 claws and install the rear seat shoulder belt cover.

HINT
Use the same procedures for the RH side and the LH side.

6. CONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side)

(a) Connect the floor end of the rear seat outer belt assembly with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the rear seat outer belt assembly to overlap protruding parts of the floor panel.

(b) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

8. INSTALL ROOF SIDE INNER GARNISH LH Installation

9. INSTALL ROOF SIDE INNER GARNISH RH Installation

10. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for TMC Made) Installation

11. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for TMMK Made) Installation

12. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH Installation

13. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH (for Reclining Seat Type) Reassembly

14. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (for Reclining Seat Type)

HINT
Use the same procedures for the RH side and the LH side.

15. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation

16. INSTALL REAR DOOR SCUFF PLATE LH Installation

17. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

18. INSTALL REAR DOOR SCUFF PLATE RH Installation

19. INSTALL CENTER SEAT BACK ASSEMBLY (for Reclining Seat Type) Installation

20. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Reclining Seat Type) Installation

21. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Reclining Seat Type) Installation

22. INSTALL REAR SEAT BACK COVER (for Reclining Seat Type)

23. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation

24. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH (for Fold Down Seat Type)

HINT
Use the same procedures for the RH side and the LH side.

25. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation

26. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Fold Down Seat Type) Installation

27. INSTALL REAR SEAT BACK ASSEMBLY (for Fixed Seat Type) Installation

28. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

29. INSTALL REAR SEAT HEADREST ASSEMBLY

30. INSTALL REAR SEAT CUSHION ASSEMBLY Installation