Removal

2AR-FE FUEL: FUEL INJECTOR: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

HINT
Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for PZEV) Removal

5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (except PZEV) Removal

6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

12. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal

13. REMOVE COWL TOP OUTER FRONT PANEL SUB-ASSEMBLY Removal

14. DISCONNECT FUEL TUBE SUB-ASSEMBLY

(a) Remove the No. 1 fuel pipe clamp.





(b) Pinch the tube connector, and then pull the tube connector off of the pipe.





NOTICE:
* Check for foreign matter in the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the connector and fuel pipe.
* Do not use any tools to separate the connector and pipe.
* Do not forcefully bend, kink or twist the hose.
* Keep the connector and pipe free from foreign matter.
* If the connector and pipe are stuck together, pinch the connector and turn it carefully to disconnect it.
* Put the connector in a plastic bag to prevent damage and contamination.

(c) Remove the fuel tube sub-assembly from the fuel hose clamp.

15. DISCONNECT WIRE HARNESS





Disconnect the 4 fuel injector connectors.

(a) Disconnect the 3 connectors.

(b) Remove the 2 bolts and 2 wire harness brackets.

(c) Detach the 2 clamps to disconnect the wire harness.

16. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) Removal

17. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

(a) Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injectors.





NOTICE:
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

(b) Remove the 2 fuel delivery spacers from the cylinder head.





(c) Remove the 4 injector vibration insulators from the cylinder head.

18. REMOVE FUEL INJECTOR ASSEMBLY

(a) Pull the 4 fuel injectors out of the fuel delivery pipe.