Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

HINT
* Use the same procedures for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.
* The procedures listed below are for the No. 3 parking brake cable assembly.

1. PRECAUTION

Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Manual Seat)

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working (for TMC Made: Airbag System (for TMC Made), except TMC Made: Airbag System (except TMC Made)).

3. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

HINT
Refer to the procedures up to "REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)" Removal.

4. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)

HINT
Use the same procedures for the RH side and the LH side.

5. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)

HINT
Refer to the procedures up to "REMOVE FRONT SEAT ASSEMBLY (for Power Seat)" Removal.

6. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT
Use the same procedures for the RH side and the LH side.

7. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY (for Manual Transaxle)

HINT
Refer to the procedures up to "REMOVE PARKING BRAKE LEVER" Removal.

8. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for Manual Transaxle) Disassembly

9. REMOVE PARKING BRAKE PEDAL ASSEMBLY (for Automatic Transaxle)

HINT
Refer to the procedures up to "REMOVE PARKING BRAKE PEDAL" Removal.

10. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle) Disassembly

11. REMOVE LUGGAGE DOOR LOCK OPEN LEVER SUB-ASSEMBLY (for Automatic Transaxle) Removal

12. REMOVE FRONT FLOOR CARPET ASSEMBLY (for Automatic Transaxle) Removal

13. REMOVE CROSS MEMBER FLOOR NO. 4 REINFORCEMENT SUB-ASSEMBLY (for Automatic Transaxle) Removal

14. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle)

(a) Separate the No. 3 parking brake cable assembly from the parking brake equalizer.

15. SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle)

(a) Separate the No. 2 parking brake cable assembly from the parking brake equalizer.

16. REMOVE NO. 4 PARKING BRAKE CABLE ASSEMBLY (for Automatic Transaxle)

(a) Slide the rubber boot as shown in the illustration.

(b) Remove the No. 4 parking brake cable assembly from the parking brake equalizer as shown in the illustration.

17. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for Dual Type)

HINT
* for 2AR-FE: Removal
* for 2GR-FE: Removal

18. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for Single Type) Removal

19. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for Dual Type)

HINT
* for 2AR-FE: Removal
* for 2GR-FE: Removal

20. REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover) Removal

21. REMOVE NO. 1 FLOOR UNDER COVER (w/ Cover) Removal

22. REMOVE NO. 2 FRONT FLOOR HEAT LOWER INSULATOR (for 2AR-FE)

(a) Remove the 3 nuts and the No. 2 front floor heat lower insulator.

23. REMOVE REAR WHEEL

24. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Disassembly

25. REMOVE REAR DISC Disassembly

26. REMOVE PARKING BRAKE SHOE RETURN TENSION NO. 1 SPRING Disassembly

27. REMOVE PARKING BRAKE SHOE STRUT Disassembly

28. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY Disassembly

29. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET Disassembly

30. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY Disassembly

31. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the backing plate.

(b) Using needle-nose pliers, remove the clip from the No. 3 parking brake cable assembly.

(d) Remove the No. 3 parking brake cable assembly from the body.

(e) Remove the parking brake cable clamp.