Removal (to 12/2010)

INTERIOR: ROOF HEADLINING: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE FRONT SEAT ASSEMBLY LH

HINT
Removal (to 12/2010)

3. REMOVE FRONT SEAT ASSEMBLY RH

HINT
Removal (to 12/2010)

4. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY Removal

5. REMOVE REAR SEATBACK ASSEMBLY

HINT
Removal

6. REMOVE LOWER NO.2 STEERING WHEEL COVER Removal (to 12/2010)

7. REMOVE LOWER NO.3 STEERING WHEEL COVER Removal (to 12/2010)

8. REMOVE STEERING PAD Removal (to 12/2010)

9. REMOVE STEERING WHEEL ASSEMBLY Removal (to 12/2010)

10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal (to 12/2010)

11. REMOVE POSITION INDICATOR HOUSING ASSEMBLY Removal (to 12/2010)

12. REMOVE SEAT HEATER SWITCH (w/ Seat Heater) Removal (to 12/2010)

13. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal (to 12/2010)

14. REMOVE CONSOLE BOX CARPET

15. REMOVE CONSOLE BOX ASSEMBLY Removal (to 12/2010)

16. REMOVE FRONT CONSOLE BOX Removal (to 12/2010)

17. REMOVE FLOOR SHIFT ASSEMBLY Removal (to 12/2010)

18. REMOVE FRONT DOOR SCUFF PLATE LH

(a) Disengage the 4 clips and 7 claws and remove the front door scuff plate LH.

19. REMOVE FRONT DOOR SCUFF PLATE RH

HINT
Removal of the front door scuff plate RH is the same as the front door scuff plate LH.

20. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

(a) Remove the clip (A).

(b) Disengage the 2 clips (B) and remove the cowl side trim sub-assembly LH.

21. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT
Removal of the cowl side trim sub-assembly RH is the same as the cowl side trim sub-assembly LH.

22. REMOVE REAR DOOR SCUFF PLATE LH

(a) Disengage the 5 clips and 2 claws and remove the rear door scuff plate LH.

23. REMOVE REAR DOOR SCUFF PLATE RH

HINT
Removal of the rear door scuff plate RH is the same as the rear door scuff plate LH.

24. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

25. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

26. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

27. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

28. REMOVE LAP BELT OUTER ANCHOR COVER

(a) Disengage the 2 claws and remove the lap belt outer anchor cover.

29. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY LH

(a) Remove the bolt.

30. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY RH

HINT
Removal of the front seat outer belt assembly RH is the same as the front seat outer belt assembly LH.

31. REMOVE CENTER PILLAR LOWER GARNISH LH

(a) Disengage the 2 clips and 2 claws and remove the center pillar lower garnish LH.

32. REMOVE CENTER PILLAR LOWER GARNISH RH

HINT
Removal of the center pillar lower garnish RH is the same as the center pillar lower garnish LH.

33. REMOVE CENTER PILLAR GARNISH LH

(a) Remove the bolt.

(b) Disengage the 2 clips and remove the center pillar garnish LH.

34. REMOVE CENTER PILLAR GARNISH RH

HINT
Removal of the center pillar garnish RH is the same as the center pillar garnish LH.

35. REMOVE REAR SEAT SIDE GARNISH LH

(a) Disengage the 4 clips and 2 claws and remove the rear seat side garnish LH.

36. REMOVE REAR SEAT SIDE GARNISH RH

HINT
Removal of the rear seat side garnish RH is the same as the rear seat side garnish LH.

37. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

(a) Disengage the 3 clips (A).

(b) Pull the roof side inner garnish assembly LH forward, disengaging from the metal clip (B).

(c) Remove the metal clip (B) from the body.

38. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT
Removal of the roof side inner garnish assembly RH is the same as the roof side inner garnish assembly LH.

39. SEPARATE REAR OUTER SEAT BELT ASSEMBLY Removal (to 12/2010)

40. SEPARATE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH Removal (to 12/2010)

41. SEPARATE REAR OUTER SEAT BELT ASSEMBLY Removal (to 12/2010)

42. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY Removal (to 12/2010)

43. REMOVE FRONT PILLAR GARNISH LH

(a) Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the clips (A) and (B).

HINT
Make the front pillar garnish LH hang down from the front pillar garnish clip.

(b) Turn the end of the front pillar garnish clip 90° with needle-nosed pliers and remove it from the front pillar garnish LH.

NOTICE:
* Front pillar garnish clips are reusable if they are not removed from the vehicle and have no damage.
* Replace the front pillar garnish clips with new ones if they are removed from the vehicle.

HINT
Tape the tips of the needle-nosed pliers before use.

(c) Remove the front pillar garnish LH.

(d) Protect the curtain shield airbag.

NOTICE:
Cover the curtain shield airbag with the protection cover as soon as the front pillar garnish is removed.

(1) Cover the airbag with cloth or nylon of 700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the ends of the cover with tape, as shown in the illustration.

44. REMOVE FRONT PILLAR GARNISH RH

HINT
Removal of the front pillar garnish RH is the same as the front pillar garnish LH.

45. REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY

(a) Disengage the 3 claws and remove the cover.

HINT
Tape the screwdriver tip before use.

(b) Slightly push in the clips with your fingers and remove them from the assist grip sub-assembly.

(c) Remove the clips from the body.

46. REMOVE ASSIST GRIP SUB-ASSEMBLY

HINT
Removal of the assist grip sub-assembly is the same as the assist grip sub-assembly front.

47. REMOVE VISOR BRACKET COVER

(a) Using a moulding remover, disengage the 3 claws and remove the visor bracket cover.

48. REMOVE VISOR ASSEMBLY LH

(a) Remove the 2 screws and the LH visor assembly.

49. REMOVE VISOR ASSEMBLY RH

HINT
Removal of the RH visor assembly is the same as the LH visor assembly.

50. REMOVE ROOF CONSOLE BOX ASSEMBLY

(a) Using a moulding remover, disengage the 2 clips and remove the roof console box assembly.

51. REMOVE REAR INTERIOR LIGHT ASSEMBLY

(a) Using a moulding remover, disengage the 6 claws and remove the rear interior light assembly.

52. REMOVE VISOR HOLDER

(a) Remove the holder of the sun visor by turning it to the left.

53. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (W/ Garage Door Opener) Removal

54. REMOVE RAIN SENSOR COVER (w/ Auto Wiper) Removal

55. REMOVE RAIN SENSOR (w/ Auto Wiper) Removal

56. REMOVE SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof)

(a) Remove the sun roof opening trim moulding.

57. REMOVE ROOF HEADLINING ASSEMBLY

(a) Disengage the 4 clips.

(b) Remove the roof headlining assembly from the passenger's door.

(d) Remove the antenna cord sub-assembly with roof wire.