Removal

SEAT: REAR SEAT ASSEMBLY: REMOVAL

HINT
Only installation procedures requiring additional information are included.

1. REMOVE REAR SEAT CUSHION ASSEMBLY

(a) Pull up the 2 portions of the rear seat cushion assembly as shown in the illustration and remove it.

A:

100 mm (3.94 in.) or less

NOTICE:
In this case, hold the base of the clip up to prevent the cushion frame from being distorted.

(b) Disconnect each wire of the reclining adjuster arm sub-assembly RH and remove the rear seat cushion assembly.

2. REMOVE REAR SEAT HEADREST ASSEMBLY

3. REMOVE REAR SEATBACK LOCK COVER CAP

(a) Disengage the 6 claws and remove the 2 RR shelf cover caps.

4. REMOVE REAR SEATBACK ASSEMBLY LH

(a) Remove the rear seat belt from the rear seat shoulder belt guide LH.

(b) Remove the bolt, 2 nuts and the rear seatback assembly LH.

5. REMOVE REAR SEATBACK ASSEMBLY RH

(a) Remove the rear seat belt from the rear seat shoulder belt guide RH.

(b) Remove the rear seat belt from the rear seat shoulder belt guide center.