Trim Panel: Service and Repair

Trim Removal and Installation

Removal

Front pillar trim

1) Remove front pillar trim (1) by pulling in arrow direction.






Dash side trim

2) Remove side sill inner front scuff.
3) Remove dash side trim (1) by pulling it in arrow direction.






Side sill inner front scuff / Side body outer front scuff

4) Remove side sill inner front scuff (1) by pulling it in arrow direction.
5) Remove side body outer front scuff (2).






Side sill inner rear scuff / Side body outer rear scuff

6) Remove side sill inner rear scuff (1) by pulling it in arrow direction.
7) Remove side body outer rear scuff (2).






Center pillar upper trim/lower trim

8) Remove side sill inner front scuff and side sill inner rear scuff.
9) Set slider (1) at rear end position.
10) Remove cap (3) of center pillar lower trim.
11) Remove center pillar lower trim (2).





12) Remove seat belt anchor bolt. Removal and Installation
13) Remove center pillar upper trim screw (4) and center pillar upper trim (5).






Rear pillar inner trim

14) Remove rear seat cushion. Removal and Installation
15) Fold down rear seat.
16) Remove rear bolster. Rear Bolster Removal and Installation
17) Remove rear pillar inner trim (1) by pulling it in arrow direction.






Partition trim

18) Remove rear seat cushion. Removal and Installation
19) Fold down rear seat.
20) Remove rear bolsters. Rear Bolster Removal and Installation
21) Remove rear pillar inner trims.
22) Remove rear side air bag (inflator) modules. Removal and Installation
23) Remove seat belt center cover (2).
24) Remove rear seat belt anchor bolts. Components
25) Remove partition trim (1) by pulling it in arrow direction.





Trunk rear trim

26) Remove trunk lid opening weather-strip. Service and Repair
27) Open cover of cargo net hooks (1).
28) Remove cargo net hook screws (2).
29) Remove cargo net hooks.
30) Remove trunk rear trim (3).






Trunk side trim

31) Remove trunk rear trim.
32) Remove cargo net hooks (1) and cargo net hook screws (2).
33) Remove trunk side trim (3).






Trunk lid trim

34) Remove trunk lid inner handle (1).
35) Remove trunk lid trim (2).
36) Remove trunk lid hinge garnish (3).






Installation

Reverse removal procedure noting the following points.

- Tighten rear seat belt anchor bolts to specified torque. Components
- Do not pinch roof side air bags when installing front pillar trims.
- Face hook portion upward when installing cargo net hooks.