Installation

CLUTCH: CLUTCH ACCUMULATOR: INSTALLATION

1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY

(a) Install the clutch accumulator assembly to the transaxle assembly with the 3 bolts.

Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)

(b) Install the clutch hose with a new clip (C).





(c) Temporarily install the bleeder to accumulator tube and accumulator to flexible hose tube.

(d) Using a union nut wrench, tighten the 4 union nuts (B).

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

(e) Connect the clutch line clamp with the bolt (A).

Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)

2. FILL BRAKE FLUID RESERVOIR Installation

3. BLEED CLUTCH LINE Procedures

4. INSPECT FLUID LEVEL IN RESERVOIR Testing and Inspection

5. INSPECT FOR FLUID LEAK Installation

6. INSTALL BATTERY CARRIER Installation

7. INSTALL BATTERY TRAY

8. INSTALL BATTERY

9. INSTALL BATTERY INSULATOR

10. INSTALL BATTERY CLAMP SUB-ASSEMBLY Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

12. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

13. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation