FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Replacement





U760E AUTOMATIC TRANSMISSION / TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT

1. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the 5 clips and rear engine under cover LH.





(b) Remove the refill plug and gasket from the automatic transaxle assembly.





(c) Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle assembly.





(d) Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle assembly.





Text in Illustration





(e) Drain the automatic transaxle fluid from the automatic transaxle assembly.

(f) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle assembly.

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)

(g) Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle.

HINT
Reuse the old gasket. The overflow plug will be removed again to adjust the fluid level.

(h) Temporarily install the gasket and refill plug to the automatic transaxle assembly.

HINT
Reuse the old gasket. The refill plug will be removed again to adjust the fluid level.

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY

Removal

3. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the transaxle case oil seal.





SST : 09308-00010

4. REMOVE FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the front transaxle case oil seal.





SST : 09308-00010

5. INSTALL TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new transaxle case oil seal with a small amount of MP grease.





(b) Using SST and a hammer, tap in the transaxle case oil seal.

SST : 09316-10010

SST : 09950-70010

09951-07100

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

6. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new front transaxle case oil seal with a small amount of MP grease.





(b) Using SST and a hammer, tap in the front transaxle case oil seal.

SST : 09316-60011

09316-00011

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

7. INSTALL FRONT DRIVE SHAFT ASSEMBLY

Installation

8. ADD AUTOMATIC TRANSAXLE FLUID Service and Repair

9. ADJUST AUTOMATIC TRANSAXLE FLUID Service and Repair