Removal

2AR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL

1. REMOVE GENERATOR ASSEMBLY

Removal

2. REMOVE FRONT EXHAUST PIPE ASSEMBLY





(a) Disconnect the heated oxygen sensor connector.

(b) Remove the 4 bolts, 4 compression springs and front exhaust pipe.

(c) Remove the gasket from the front exhaust pipe.

(d) Remove the gasket from the exhaust manifold converter.





3. REMOVE ENGINE OIL LEVEL DIPSTICK

4. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE Removal

5. REMOVE RADIATOR HOSE CLAMP Removal

6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal

7. REMOVE MANIFOLD STAY





(a) Remove the bolt, nut and stay.

8. REMOVE NO. 2 MANIFOLD STAY





(a) Remove the bolt, nut and stay.

9. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR





(a) Remove the 4 bolts and heat insulator.

10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR





(a) Remove the 2 bolts and insulator.

11. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY





(a) Remove the 5 nuts in the sequence shown in the illustration, and then remove the manifold converter and gasket.

12. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR





(a) Remove the 4 bolts and insulator.