Installation

PARKING BRAKE: PARKING BRAKE LEVER: INSTALLATION

1. INSTALL PARKING BRAKE LEVER SUPPORT BRACKET

(a) Install the parking brake lever support bracket with the 2 bolts.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(b) Attach the 2 clamps to the parking brake lever support bracket.

2. INSTALL PARKING BRAKE SWITCH ASSEMBLY

(a) Install the parking brake switch to the parking brake lever with the screw.

Torque : 0.9 Nm (9 kgf-cm, 8 in-lbf)

3. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Pass the No. 1 parking brake cable through the parking brake lever.

(b) Bend the parking brake lever claw.





(c) Temporarily install the adjusting nut and lock nut to the No. 1 parking brake cable.

4. INSTALL PARKING BRAKE CABLE END STOPPER

(a) Install the parking brake cable end stopper to the No. 1 parking brake cable.

5. INSTALL PARKING BRAKE EQUALIZER

(a) Attach the 2 claws to install the parking brake equalizer to the parking brake cable end stopper.





(b) Attach the 2 claws to connect the parking brake equalizer to the No. 1 parking brake cable.





6. INSTALL PARKING BRAKE LEVER ASSEMBLY

(a) Install the parking brake lever with the 2 bolts.

Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

(b) Connect the parking brake switch connector.

7. CONNECT PARKING BRAKE CABLE

(a) Connect the No. 3 parking brake cable to the parking brake equalizer as shown in the illustration.





Text in Illustration





(b) Connect the No. 2 parking brake cable to the parking brake equalizer.

HINT
Use the same procedure described for the No. 3 parking brake cable.

8. INSTALL NO. 5 CROSSMEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY

(a) Install the No. 5 crossmember floor reinforcement sub-assembly with the 5 bolts.

Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(b) Install the floor carpet.

9. CHECK AND ADJUST PARKING BRAKE LEVER TRAVEL

Adjustments

10. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.