Brake Warning Light does not Come ON

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Brake Warning Light does not Come ON
- Brake Warning Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON Brake Warning Light Remains ON.

INSPECTION PROCEDURE

NOTICE:
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.
* When replacing the brake actuator assembly, perform calibration Programming and Relearning.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM ABS Warning Light Remains ON

B -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How to Proceed With Troubleshooting
A -- Continue to next step.

2. READ VALUE USING TECHSTREAM (BRAKE WARNING LIGHT) Brake Warning Light Remains ON

B -- GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How To Proceed With Troubleshooting

A -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal