Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE ACTUATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE AIR CLEANER CASE

Removal

3. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.

4. DISCONNECT CONNECTOR

(a) Pull the lock lever upward and disconnect the connector.





NOTICE:
Be careful not to allow brake fluid to enter the removed connector.

5. DISCONNECT BRAKE LINES

(a) Using a union nut wrench, disconnect the 6 brake lines from the actuator.





(b) Place tags or marks to identify the installation locations of each brake line.





HINT
* *1: to front wheel RH
* *2: to front wheel LH
* *3: to rear wheel RH
* *4: to rear wheel LH
* *5: from master cylinder

6. REMOVE BRAKE ACTUATOR WITH BRACKET

(a) Detach the 2 clamps from the bracket.





NOTICE:
The clamps cannot be reused after they are detached from the bracket.

(b) Remove the 3 nuts and actuator with bracket.





NOTICE:
Be careful not to damage the brake tubes.