Valve Cover: Service and Repair

Camshaft Cover Replacement

Removal Procedure






1. Remove the ignition coils. Refer to Ignition Coil Replacement Service and Repair.
2. Remove the ground strap and stud.
3. Disconnect the PCV hose from the cam cover.






4. Disconnect the fuel feed pipe from the fuel rail. Refer to Fuel Hose/Pipes Replacement - Engine Compartment Service and Repair.






5. Remove the camshaft cover bolts.
6. Remove the camshaft cover.

Installation Procedure

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.






1. Install the camshaft cover and bolts.

Tighten
Tighten the camshaft cover bolts to 10 Nm (89 lb in).

2. Install the ground strap to the camshaft cover.

Tighten
Tighten the ground strap stud to 10 Nm (89 lb in).






3. Install the ignition coils . Refer to Ignition Coil Replacement Service and Repair.
4. Connect the fuel feed pipe to the fuel rail. Refer to Fuel Hose/Pipes Replacement - Engine Compartment Service and Repair.
5. Install the fuel pipe bracket.

Tighten
Tighten the fuel pipe bracket bolt to 10 Nm (89 lb in).

6. Connect the PCV hose to the cam cover.