Removal And Installation

SHIFT CONTROL SYSTEM

Removal and Installation


CVT SHIFT SELECTOR COMPONENTS












CONTROL CABLE COMPONENTS

Refer to the figure below for shift selector control cable removal and installation procedure.











REMOVAL


CAUTION:
Make sure that parking brake is applied before removal and installation.
1.Place the shift selector in the "N" position.
2.Remove the center console assembly.




3.Disconnect the CVT shift selector harness connector (1).
4.Remove the key interlock cable from the CVT shift selector assembly. Service and Repair.





5.Remove the bolts (A) from the CVT shift selector assembly (1).
6.Remove exhaust front tube, center muffler and heat plates.






7.Remove the plate (1) from the CVT shift selector assembly.
White arrow indicates : Vehicle front





8.Remove the lock plate (1) from the control cable (2).
White arrow indicates : Vehicle front

9.Remove the control cable (2) from the CVT shift selector assembly.





10.Insert suitable tool at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the CVT shift selector assembly to remove the CVT
shift selector assembly from the underside of the vehicle.
White arrow indicates : Vehicle front

INSTALLATION

Installation is in the reverse order of removal.





- When installing the control cable (1) to the CVT shift selector assembly (2), make sure that the control cable (1) is fully pressed in with the ribbed surface (A) facing downward from the vehicle.
White arrow indicates : Vehicle front

- After installation is completed, adjust and check the CVT position.
Adjustments and Testing and Inspection.