Shifter CVT: Adjustments

SHIFT CONTROL SYSTEM

Adjustment of CVT Position


CAUTION:
Make sure that parking brake is applied before adjustment.





1.Loosen the control cable nut (A) and place the manual lever (1)
in "P" position.
2.Place shift selector in "P" position.
3.Push the control cable (2) in with a load of 9.8 N (approximately
1 kg, 2.2 lb). Release the shift selector control cable and temporarily tighten the shift selector control cable nut.
NOTE:
Do not move the manual lever. Make sure the manual lever stays in the "P" position.
4.Tighten the control cable nut.

CAUTION:
Secure the manual lever when tightening control cable nut.

Control cable nut:Removal And Installation.

5.Check the operation of the CVT. Testing and Inspection.