Shifter A/T: Adjustments

SHIFT CONTROL SYSTEM

Adjustment of A/T Position

Move shift selector from "P" position to "1" position. You should be able to feel the detents in each position. If the detents cannot be felt or if the position indicator is improperly aligned, the shift selector control cable needs adjustment.

CAUTION:
Make sure that parking brake is applied before adjustment.
1.Remove the air duct assembly.





2.Remove the shift selector control cable nut (A) and shift selector control cable (1) and place the manual lever (2) in the "P" position.
3.Place shift selector in "P" position.
4.Hold shift selector control cable (1) at the end and pull it with a force of 9.8 N (approximately 1 kg, 2.2 lb). Release the shift selector control cable and temporarily tighten shift selector control cable nut (A).
5.Tighten shift selector control cable nut (A) to the specified torque.
Shift selector control cable nut: .

CAUTION:
Secure manual lever when tightening nut.
6.Move shift selector from "P" to "1" position again. Make sure that shift selector moves smoothly.
7.Check A/T position. Testing and Inspection.
8.Install air duct assembly.