Shifter A/T: Testing and Inspection

SHIFT CONTROL SYSTEM

Checking of A/T Position

1.Place shift selector in "P" position, and turn ignition switch ON (Do not start engine).
2.Make sure shift selector can be moved to other than "P" position when brake pedal is depressed. Also make sure shift selector can be moved from "P" position only when brake pedal is depressed.
3.Move shift selector and check for excessive effort, sticking, noise or rattle.
4.Confirm shift selector stops at each position with the feel of engagement when it is moved through all the positions. Check whether or not the actual position shift selector is in matches the position shown by the position indicator and the transaxle.





5.The method of operating shift selector to individual positions correctly should be as shown.
- (A): Press shift selector handle button to operate shift selector, while depressing the brake pedal.
- (B): Press shift selector handle button to operate shift selector.
- (C): Shift selector can be operated without pressing shift selector handle button.
6.Confirm back-up lamps illuminate only when shift selector is placed in "R" position. Confirm back-up lamps do not illuminate when shift selector is in "P" or "N" position even if it is pushed toward "R" position without pressing shift selector handle button.
7.Confirm engine can only be started with shift selector in "P" and
"N" positions.
8.Make sure A/T is locked completely when shift selector is in "P" position.