P1574

DTC P1574 ASCD VEHICLE SPEED SENSOR

Component Description

The ECM receives two vehicle speed signals via CAN communication line. One is sent from "ABS actuator and electric unit (control unit)" or combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to Description and Operation for ASCD functions.


On Board Diagnosis Logic

NOTE:
-If DTC P1574 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
-If DTC P1574 is displayed with DTC P0500, first perform the trouble diagnosis for DTC P0500.
-If DTC P1574 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605.
-If DTC P1574 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607.

This self-diagnosis has the one trip detection logic.
The MIL will not light up for this diagnosis.







DTC Confirmation Procedure


CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Step 3 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

1.Start engine.
2.Drive the vehicle at more than 40 km/h (25MPH).
3.Check DTC.
4.If DTC is detected, go to .


Diagnosis Procedure


1. CHECK DTC WITH TCM

Check DTC with TCM. Automatic Transmission (A/T) "CONSULT
Function (TRANSMISSION)" (CVT).
OK or NG
OK- GO TO 2.
NG- Perform trouble shooting relevant to DTC indicated.

2. CHECK DTC WITH "ABS ACTUATOR AND ELECTRIC UNIT"

Scan Tool Testing and Procedures.
OK or NG
OK- GO TO 3.
NG- Repair or replace.

3. CHECK COMBINATION METER

Check combination meter function.
Combination Meters.
-INSPECTION END