P1211

DTC P1211 TCS CONTROL UNIT

Description

The malfunction information related to TCS is transferred via the CAN communication line from "ABS actuator and electric unit (control unit)" to ECM.
Always erase the malfunction information such as DTC not only for "ABS actuator and electric unit (control unit)" but also for ECM after TCS related repair.


On Board Diagnosis Logic

Freeze frame data is not stored in the ECM for this self-diagnosis.

The MIL will not illuminate for this self-diagnosis.







DTC Confirmation Procedure

TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10.5 V at idle.

1.Start engine and let it idle for at least 60 seconds.
2.Check 1st trip DTC.
3.If 1st trip DTC is detected, go to .


Diagnosis Procedure

Perform trouble diagnosis for TCS. Scan Tool Testing and Procedures.