Carpet: Service and Repair

FLOOR TRIM

Removal and Installation












REMOVAL

1.Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2.Remove front seats (RH/LH) and rear seat cushion. Driver Seat, "Passenger Seat" and Removal And Installation - 60:40 Split Fold Down Seat.
3.Remove center console assembly and bracket. Removal And Installation.
4.Remove the parking brake device assembly. Component.
a.Disconnect the parking brake switch connector.
b.Loosen the adjusting nut.
c.Remove the equalizer from the rear cable terminals d.Remove parking brake device nuts and parking brake device assembly.
5.Remove the parking brake device bracket nuts and the bracket.
6.Remove the glove box assembly. Component Parts.
7.Remove instrument lower finisher and disconnect connector. Component Parts.
8.Remove front kicking plates (RH/LH), center pillar lower finishers (RH/LH), and both upper and lower rear kicking plates (RH/LH).
9.Remove front seat belt lower anchors (RH/LH). Front Seat Belt.
10.Remove diagnosis sensor unit.
11.Remove floor carpet hook.
12.Remove instrument lower covers (RH/LH). Component Parts.
13.Remove cluster lid c. Cluster Lid C.
14.Remove instrument upper cover (center) and instrument lower cover (center). Component Parts.
15.Remove floor trim through door opening.
16.Remove floor spacers (RH/LH fronts, centers and rear).

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
For parking brake device torque specs, Component.