Front Seat Belt

SEAT BELTS

Removal and Installation of Front Seat Belt












CAUTION:
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.

REMOVAL OF SEAT BELT RETRACTOR

1.Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2.Remove the seat belt adjuster cover and shoulder anchor bolt.
3.Disconnect the belt tension sensor, then remove outer anchor cover and outer anchor bolt.
4.Remove the center pillar upper and lower garnish.
5.Position the floor trim away from center pillar.





6.Disconnect seat belt pre-tensioner connector. Supplemental Restraint System (SRS).
7.Remove the retractor anchor bolt, then remove the seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR

Installation is in the reverse order of removal.

REMOVAL OF SEAT BELT BUCKLE

1.Remove the front seat. Removal and Installation.
2.Remove the seat side cover. Front Seat.





3.Disconnect the seat belt buckle harness connector (1).
White arrow indicates : Vehicle front
4.Remove the buckle anchor bolt (A), then remove the seat belt buckle (2).

INSTALLATION OF SEAT BELT BUCKLE

Installation is in the reverse order of removal.