Removal And Installation

KEY INTERLOCK CABLE

Removal and Installation


REMOVAL


CAUTION:
Always apply the parking brake before performing removal and installation.
1.Shift the selector lever to the "N" position.
2.Remove the selector lever knob. Disassembly And Assembly.
3.Shift the selector lever to the "P" position.
4.Remove the center console. Removal And Installation.





5.Press the pawls (B) of the key interlock cable slider (A) while sliding it in the direction of the casing cap (C), and separate the adjusting holder (D) and slider.

E : Key interlock rod

6.Remove the key interlock cable from the CVT shift selector.
7.Remove the steering column lower cover and driver instrument lower panel. Removal And Installation.





8.Lift clip (A) in the direction of the arrow (C) and remove in the direction of the arrow (D).





9.Disconnect the key interlock cable from the key cylinder.
10.Disengage the clip and disconnect the key interlock cable from the vehicle.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Install the adjusting holder (A) onto the key interlock rod (B), then install the casing cap (C) onto the CVT shift selector cable bracket (D).

CAUTION:
- When installing the key interlock cable, never bend or twist the cable forcefully.
- After connecting the key interlock cable to the CVT shift selector cable bracket, be sure to check that the casing cap is completely fastened to the cable bracket. If the casing cap is easily displaced, replace the key interlock cable.





- While pressing the detent rod (B) down, slide the key interlock cable slider (A) toward the key interlock rod (D) side, and install the adjusting holder (C) and key interlock rod.

CAUTION:
- Never squeeze the pawls on the key interlock cable slider when holding the slider.
- Never apply force in a perpendicular direction to the key interlock rod when sliding the slider.