Disassembly And Assembly

CVT SHIFT SELECTOR

Disassembly and Assembly


DISASSEMBLY






1.Slide the selector lever knob cover (1) down.

CAUTION:
Never damage the knob cover.
2.Pull out the lock pin (2).
3.Pull the selector lever knob (3) and knob cover upwards to remove them.
4.Remove the position lamp.





5.Disengage the hooks (A) (4 locations), and lift up the position indication panel (1) to separate it from the CVT shift selector assembly (2).

CAUTION:
Never damage the CVT shift selector assembly.
6.Remove the shift lock unit from the CVT shift selector assembly.
7.Disconnect the park position switch connector, detent switch connector, and shift lock solenoid connector from the shift lock unit.

ASSEMBLY

Note the following, and assemble in the reverse order of disassembly.
- Follow the procedure below and place the selector knob onto the CVT shift selector.





1.Install the lock pin (2) onto the selector lever knob (3).
2.Install the knob cover (1) onto the selector lever knob.
3.Press the selector lever knob onto the selector lever until it clicks.

CAUTION:
- When pressing the selector lever knob onto the selector lever, never press the selector lever knob button.
- Never strike the selector lever knob to press it into place.