Removal And Installation

STARTER MOTOR

Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal. Removal And Installation.
2.Drain engine coolant from radiator. Draining Engine Coolant.
3.Remove charge air cooler. Removal And Installation.
4.Remove CVT water hose on thermostat housing side (CVT models). Exploded View.
5.Remove radiator hose (lower) on water inlet side. Removal And Installation.
6.Move CVT water hose A and radiator hose (lower) to a location where they do not inhibit work.





7.Open "B" terminal cover, in the direction indicated by an arrow, as shown in the figure.
8.Remove "B" terminal nut and "B" terminal harness.
9.Remove "S" terminal nut and "S" terminal harness.





10.Disconnect harness connector (1) from crankshaft position sensor.
11.Remove harness fixing clip (A) from oil pan (upper), and then move harness (2) to a location where they do not inhibit work.
12.Remove starter motor mounting bolts.
13.Remove starter motor forward from the vehicle.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- Be careful to tighten "B" terminal nut to the specified torque.
- After work is complete fill engine coolant. Refilling Engine Coolant.