Removal And Installation

HEADLINING

NORMAL ROOF : Removal and Installation


REMOVAL


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.
1.Remove front pillar garnish (LH and RH). Front Pillar Garnish.





2.Disconnect harness connector (A) from headlining and harness clips

Broken circle indicates : Clip

3.Remove center pillar upper garnish (LH and RH). Center Pillar Upper Garnish.
4.Remove back door weather-strip. With Intelligent Key System.
5.Remove luggage side upper finisher (LH and RH). Luggage Side Upper Finisher.





6.Remove all assist grips.
1.Disengage pawl of assist grip clip (1) using a remover tool (A). Slide assist grip clip forward and remove it.

Broken triangle indicates : Pawl

2.Slide assist grip (2) forward and remove it.
3.Remove metal clips.
7.Remove sun visor assembly (LH and RH).





1.Disengage sun visor cover fixing pawls with a remover tool (A), and then remove sun visor cover.

Broken triangle indicates : Pawl

2.Remove sun visor assembly fixing screw, and then remove sun visor assembly.
8.Remove map lamp assembly. Removal And Installation.
9.Remove front seat assembly (passenger). Removal and Installation.
10.Remove sun visor holder (LH and RH).





Rotate 90�. Remove toward vehicle lower.
11.Remove headlining clips.





12.Remove headlining assembly through the back door.

CAUTION:
- Two workers are required for removal in order to prevent damage.
- Apply protective tape to the portion where contact may occur during work.
- Never bend headlining when removing.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- When installing headlining, start by installing both sun visor holders and headlining clips in order to keep the headlining in position.
- Never bend headlining when installing.
- Be careful that the surface is not wrinkled when installing.