Front Pillar Garnish

BODY SIDE TRIM

FRONT PILLAR GARNISH : Removal and Installation


REMOVAL


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.
1.Release front pillar garnish portion of front body side welt.





2.Remove front pillar garnish.
1.Disengage front pillar garnish fixing clips with a remover tool (A).

Broken circle indicates : Clip

2.Twist clip portion of front pillar garnish using long nose pliers while pulling upper side of front pillar garnish toward inside, and then remove clip from front pillar garnish side.
3.Remove front pillar garnish of pull toward the arrow direction.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- When installing front pillar garnish, check that clips are securely in body panel holes, and press them in.
- Replace front pillar garnish with a new part after removal. Never reuse front pillar garnish.