With Intelligent Key System

B210D STARTER RELAY

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC B210D is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. IPDM E/R With I-Key.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE 1

1.Press push-button ignition switch under the following conditions to start engine, and wait 5 seconds or more.
-Selector lever: In the P position
-Brake pedal: Depressed
-Shift lever: In the Neutral position
-Clutch pedal: Depressed
2.Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT.
Is DTC detected?
YES- Go to .
NO (M/T models)-INSPECTION END
NO (CVT models-GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE 2

1.Stop engine.
2.Perform DTC CONFIRMATION PROCEDURE for DTC P1650. P1650.
3.Turn ignition switch ON.
4.Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT.
Is DTC detected?
YES- With Intelligent Key System.
NO- INSPECTION END


Diagnosis Procedure


1. INSPECTION START

Perform inspection in accordance with procedure that confirms DTC.
Which procedure confirms DTC?
DTC confirmation procedure 1-GO TO 2.
DTC confirmation procedure 2-GO TO 3.

2. INSPECTION START

1.Turn ignition switch ON.
2.Select "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT.
3.Touch "ERASE".
4.Perform DTC CONFIRMATION PROCEDURE for DTC B210D. .
Is DTC detected?
YES- Replace IPDM E/R. IPDM E/R (With I-Key).
NO- INSPECTION END

3. CHECK IGNITION POWER SUPPLY NO.2 SIGNAL

1.Turn ignition switch OFF.
2.Disconnect IPDM E/R connector.
3.Check voltage between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- Replace IPDM E/R. IPDM E/R (With I-Key).
NO- GO TO 4.

4. CHECK BCM INPUT SIGNAL CIRCUIT

1.Disconnect BCM connector.
2.Check continuity between IPDM E/R harness connector and BCM harness connector.





3.Check continuity between transmission range switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace harness.

5. REPLACE BCM

1.Replace BCM. With Intelligent Key System.
2.Perform DTC CONFIRMATION PROCEDURE for DTC B210D .
Is the inspection result normal?
YES- INSPECTION END
NO- Replace IPDM E/R. IPDM E/R (With I-Key).